Last week someone contacted me in regards the Acrobat 4 RC.
Typical story;
Hello Forester , bla blah bla, I bought one roulette computer somewhere else but I was scammed, but your site looks genuine bla, bla.
I will buy your RC if you can predict video spins I send you because I read at roulettesystemsreviews that you are scammer ;D ;D ;D.
I accepted the offer not to convince him in to buying but just as a personal challenge and because from few sentences he could understand why such review from The Scammer Stefano.
First he sent me 3 full spins where all hits were at DD9. If I have to base my prediction on that I would have to set it as tilt, I explained him also saying it would be to easy. He said no the ball hits at all places.
Well then send me spins as that, because I can set the system only based on what I see.
New spins one was 9 rotations long the others a bit longer but he cuts video at ~7 the rotation.
It means set for earlier rotations is based only on 2 spins while after 9th it uses 3. Such points changes at the moment of perdition especially with small amount of rotations clocked should be avoided. Some spins for prediction were also to short, I had to clock rotor , then start spin again to be able to predict and still often had to use very first ball rotations. (Still significantly including back spinning on the ball making predictions unstable)
Problems with spins, with recording he moves camera, it is from to low angle so the DD6 and DD12 look as 120 degrees. Making distorted view so it is hard to define position of the ball and numbers. I asked is it 8 diamonds wheel , firstly he wasn’t sure then he confirmed it.
All I can do is to set on 3 supplied spins and predict. But then how to experience full power of the Acrobat 4. I need to be able after every spin or at least some spins to tell the FF at which diamond the ball dropped, so it can learn better which ball speeds end where. The system need to know is the ball arriving to last rotation as expected.
The wheel actually looked to me as it could be easy predicted, not so wide ball jumps and the ball dcc was ok. The main problem was some spins to short spins and NMB.
So really we can’t fully test the Acrobat 4 on that way. The only way is to have something as 50 full spins and to predict them on a same way as when I make training videos. When recording FF predictions it would hard to cheat and to place all beeps in right place.
Conclusion,
The Acrobat 4 can’t be fully tested without seeing the end of the spin. The Acrobat 4 is a head of all previous roulette computers. It continuously learns and for that uses everything from the spins.